Rewiring

Many older Brisbane homes, especially Queenslanders and post-war houses, are still running on wiring that was never designed for split systems, induction cooktops, pool pumps and a power point full of chargers in every room. Ageing cable insulation breaks down, old fuse boards can't protect modern circuits, and every new appliance adds load to a system that's already at its limit. Rewiring replaces that old cabling with modern, safety-switch-protected circuits, so your home is safer and ready for whatever you plug in next, including a new air conditioner.

Signs your home needs rewiring

  • Lights that flicker or dim when an appliance or the air con starts up
  • Circuit breakers that trip often, or fuses that keep blowing
  • Power points or switch plates that feel warm, crackle or show scorch marks
  • A burning or hot plastic smell with no obvious cause
  • An old switchboard with ceramic rewireable fuses
  • Black rubber-insulated cable in the roof space or under the house
  • Two-pin power points, or power points with no earth
  • Not enough power points, so you're relying on double adaptors and power boards
Safety switches have been mandatory in new Queensland homes since 1992. Queensland also requires them on power point circuits when a home is sold or rented out, and only a licensed electrician can install one.
source: Electrical Safety Office Queensland

What type of wiring is in your home?

The age of your home is a good guide to what's behind the walls. Our electricians will inspect the roof space, subfloor and switchboard to confirm what you have before quoting.

Common wiring types found in Brisbane homes
Era (approx.) Wiring type What happens with age Recommendation
Pre-1950s VIR (vulcanised India rubber), often in conduit or timber casing Rubber insulation perishes and crumbles, leaving bare conductors Replace
1950s – 1960s TRS (tough rubber sheathed) cable Sheathing hardens and cracks, especially in hot roof spaces Replace
1960s onwards TPS (thermoplastic/PVC sheathed) cable Generally sound, but may be undersized or poorly modified over the years Inspect and test
Older switchboards Ceramic rewireable fuses, no safety switches Slow protection, easy to overload, no protection against electric shock Switchboard upgrade

What our rewiring service includes

Inspection and quote

We check the roof space, subfloor, switchboard and every circuit, then give you a written, itemised quote.

Switchboard upgrade

Old fuses are replaced with circuit breakers and safety switches (RCDs) on every circuit, with room for future additions.

New cabling and circuits

Old cable is replaced and circuits are split sensibly, so the kitchen, laundry and air conditioning aren't sharing one overloaded line.

Power points and lighting

Extra power points where you actually need them, plus LED lighting, USB outlets and outdoor power if required.

Testing and certification

Every circuit is tested to the AS/NZS 3000 Wiring Rules, and you receive a certificate of testing and safety on completion.

Rewiring and your air conditioning

Rewiring is the ideal time to plan for air conditioning. A reverse-cycle split system should run on its own dedicated circuit from the switchboard, with an isolator switch beside the outdoor unit. Adding a new system to an old, shared circuit is a common cause of nuisance tripping, dimming lights and overheated cabling.

Wiring rules have also changed. Since 30 April 2023, the correct type of safety switch must be matched to the equipment on each circuit, and the older Type AC safety switches can no longer be installed. Because we handle both the electrical work and the air conditioning installation, the circuit, safety switch and system are planned together, so there's no handover between trades.

What affects the cost of rewiring?

Every home is different, so we quote after an inspection rather than giving a one-size-fits-all price. The main factors are:

  • The size of the home and number of circuits
  • Access: highset Queenslanders with open subfloors are usually quicker than slab homes or two-storey houses
  • Whether the switchboard also needs replacing
  • How many new power points, lights and dedicated circuits you add
  • Whether walls are open (renovations) or the home is fully lined and furnished

If you're renovating, rewiring while walls and ceilings are open is far easier and usually costs less.

Rewiring FAQs

Can I stay in my home while it's being rewired?

Usually, yes. We work through the house in sections and restore power at the end of each day wherever possible.

Do I need to rewire the whole house?

Not always. If some of the wiring is modern TPS cable in good condition, a partial rewire and switchboard upgrade may be enough. We'll tell you honestly after the inspection.

Can I do any of the wiring myself?

No. In Queensland, all electrical wiring work must be done by a licensed electrician. DIY electrical work is illegal and dangerous.

Close up of electrician working with wire strippers